I just purchased a line 6 G 90 guitar system I play a cole clark acoustic guitar FL3 I anm having trouble getting enough signal out of my G90 there is no sensitivity control on the G 90 .I can turn my on board pickup up however then you invite feedback issues I was looking at placing a sansamp rpm after my G90 to boost signal to my G natural fx pedal so I dont have to turn it up so high to gain signal to the board when I run my G natural so hot a lot of white noise comes through so I thought I could boost my signal after my wireless and turn down my gain at my fx unit any suggestions on this thanks are the sansamp rpms good pres? any ideas thanks.
05-17-2011, 07:38 AM
need some level
