#16
|
|||
|
|||
Make a feedback buster from scrap soundhole cutouts...
Just a few more that I've made, these two were actual converted soundhole cutouts direct from the manufacturer.
This one is a matching half koa/mango in the signature KoAloha "musubi" shape:
__________________
AGF rules say I must tell you that I'm a KoAloha Ukulele sponsored artist. Last edited by joeguam; 02-19-2015 at 09:24 PM. |
#17
|
|||
|
|||
Wanted to share this, if your sound hole is cutout using a laser, the fit is so perfect that you don't need the rubber lining. KoAloha Ukulele uses laser for their cuts and I just used "office supply" double-stick cellophane tape wrapped around the cutout to hold it in place. Here's a shot of a custom special issue tenor the guys at KoAloha built for me. They use laser technology for their fretboard inlay work and it is amazing. Dislaimer: Per AGF rules I must disclose that I am a KoAloha Ukulele supported artist. Sent from my iPhone using Tapatalk
__________________
AGF rules say I must tell you that I'm a KoAloha Ukulele sponsored artist. |
#18
|
|||
|
|||
Very cool Joe.
|
#19
|
||||
|
||||
Joe, I want to try this. Thank you! Did you have to sand the sounhole cutout perimeter at all? And how did you attach the weather stripping... Glue?
__________________
i got tired of updating my guitars. |
#20
|
|||
|
|||
Yes, if you're using the rubber lining, you might have to sand it a little bit.
The lining has double stick mounting tape on it, so I just fastened it to the cutout with that. I do recommend to glue two cutouts together if you have them...it'll make for a better fit. Sent from my iPhone using Tapatalk
__________________
AGF rules say I must tell you that I'm a KoAloha Ukulele sponsored artist. |