#1
|
|||
|
|||
no relief
I have a new Gretsch Electromatic with no relief in the neck. There is buzzing any time I move up the fingerboard beyond the 3rd fret. I have slowly backed off the truss rod to now where it is completely slack. The neck is as straight as an arrow. Any suggestions?
|
#2
|
|||
|
|||
Does your guitar use a dual action or single action truss rod? I've only owned a dual action one so I'm not sure how to adjust single action. If it's a dual action, try turning the truss rod gently and slightly to the left and play a bit and hear string buzz. If that helps, keep doing so until the string buzz is resolved. Turning the rod to the left adds relief. If it gets stiff, don't force it or you'd be in deep waters. Sometimes a small relief is all it needs.
Sorry. Had left and right mixed up. Edited my post.
__________________
Martin D-13E (2021 MiM) Last edited by LeDave; 09-12-2020 at 04:22 PM. |
#3
|
|||
|
|||
I'd try going up one gauge heavier in strings. I find my short scale guitars do better heavier gauge strings. I run 10s on my Projet and the action is still slinky.
|
#4
|
|||
|
|||
Just wait. It takes time for tension to pull some relief in. Give it a month.
|
#5
|
|||
|
|||
Gretch should be able to tell you if you have a dual action truss rod or not.
__________________
2007 Martin D 35 Custom 1970 Guild D 35 1965 Epiphone Texan 2011 Santa Cruz D P/W Pono OP 30 D parlor Pono OP12-30 Pono MT uke Goldtone Paul Beard squareneck resophonic Fluke tenor ukulele Boatload of home rolled telecasters "Shut up and play ur guitar" Frank Zappa |
#6
|
|||
|
|||
A double action rod will tighten up when you turn it counterclockwise. There usually is a dead spot in the middle where nothing happens and the nut is relatively loose.
When loosening most single action rods, the nut will remain loose and eventually come off if you keep turning it. |