#1
|
||||
|
||||
changing tuners on AP66 today ... any tips?
So I've decided today is the day.
I've had my Alvarez AP66 (all mahogany) for a couple months now, and I love it - she's a keeper for sure ... the only shortcoming I can find is the tuners. So I snagged a set of Grover drop-in replacements from Stew-Mac, had Grover send me the shorter screws (as recommended by others), and I'm ready to do the deed. So I ask the brain trust here on AGF if there are any tips or tricks or anything I should know before I begin. It looks pretty straightforward, but being a noob to guitar upgrades / repairs, thought it might be prudent to ask ... Thanks! ~ Paul
__________________
` “Success is falling down nine times and getting up ten.” |
#2
|
|||
|
|||
Don’t forget to take string off first..
But seriously it’s very easy to swap tuners. Take your time and it will be fine. |
#3
|
|||
|
|||
Highly recommend not using a power screwdriver. I snapped a screw off and had to take it to Gryphon and salvage it and not have it look like crap digging the screw out. I was lucky but never again with a power screw driver
|
#4
|
|||
|
|||
I replaced mine with probably the same tuners. There were finish drips inside the holes that I scoured out with a 1/4" drill bit. You don't need the bushings that come with the tuners. The tuner holes in mine were not quite perpendicular to the headstock on one side, which made the old tuners bind a lot, and the new ones bind a little. I had to put washers under one side to tilt them slightly. I think that's an unusual problem that you probably won't have.
Full details here: https://www.acousticguitarforum.com/...d.php?t=333862 |
#5
|
|||
|
|||
Quote:
Wouldn’t it have been a better install if you redrilled the tuner holes to correct their alignment and installed the included bushings?
__________________
Taylor V-Class 814ce, 717e BE WHB, 520ce, 454ce, 420 Cedar\Maple, T5z Classic Martin D18E Retro Cordoba C10 Crossover Emerald X20 Rainsong H-OM1000N2 Voyage-Air VAD-04 Custom Les Paul Hot Rod Deville 410, Fishman Loudbox Performer |
#6
|
|||
|
|||
Quote:
We're talking dining-room table workbench here. It's the beer-can shim from Zen and the Art of Motorcycle Maintenance. |