|
|
#1
09-20-2018, 07:57 AM
|
|||
|
|||
LR Baggs Element installation question
Hi,
Maybe I too curious, but I'm wondering if there is any difference which side of the pickup element itself is on top? There is small black dot at the end of one of the sides but installation manual does not say if there is one proper way of mount it. Any ideas? Regards, Marek
__________________
Camps 2000 Premium, Wieslaw Dlugosz Custom 
|
|
#2
09-20-2018, 08:58 AM
|
|||
|
|||
|
I've installed quite a few and never even considered it.
__________________
jf45ir Free DIY Acoustic Guitar IR Generator .wav file, 30 seconds, pickup left, mic right, open position strumming best...send to direct email below I'll send you 100/0, 75/25, 50/50 & 0/100 IR/Bypass IRs IR Demo, read the description too: https://youtu.be/SELEE4yugjE My duo's website and my email... [email protected] Jon Fields
|
|
#3
09-20-2018, 09:18 AM
|
|||
|
|||
|
I'd check with Baggs on their forum but I don't think there's a difference. The old Baggs Ribbon Transducer had different properties based on which way you installed it but I think the Element is a pretty flexible and uncomplicated install. When you consider that, before the Element, the Baggs piezos were the LB6 (which replaces your saddle, requires more intensive install) and the Ribbon (super low output, feedback prone), it was a sensible "next gen" replacement. I'm sure there are plenty who prefer the LB6 (myself) or Ribbon to the Element but if the goal is to make a quality UST that can be easily installed in a guitar or sold as stock pickup in production guitars, the Element succeeded at that.
__________________
Alvarez MC90 Guild GAD-50 w/Seymour Duncan Mag Mic Taylor 352ce Taylor 514ce Zoom AC3 https://linktr.ee/erikjmusic
|
