#1
|
|||
|
|||
Great video - action height, intonation, fret buzz and more
This video, despite being 38 minutes long have taught me more than I'll ever learn in a very long time without it. I just started playing guitar a little over a month ago and I'm grateful for landing on this one.
Thought I'd like to share because it's been so dang helpful.
__________________
Martin D-13E (2021 MiM) |
#2
|
|||
|
|||
Uhm, the white thing that gets removed is called a saddle. The dark thing it sits in is called a bridge. The rest of the video is similarly accurate. There are far better sources of information.
|
#3
|
||||
|
||||
Decent video, and yes the word "saddle" was used several times, etc.
__________________
Derek Coombs Youtube -> Website -> Music -> Tabs Guitars by Mark Blanchard, Albert&Mueller, Paul Woolson, Collings, Composite Acoustics, and Derek Coombs "Reality is that which when you stop believing in it, doesn't go away." Woods hands pick by eye and ear
Made to one with pride and love To be that we hold so dear A voice from heavens above |
#4
|
|||
|
|||
If I were to install a shorter-in-height saddle onto the guitar that already plays good, chances are I'll need to do a truss rod adjustment of lefty loosy rather than a righty tighty, right? My action is a bit too high, I fear for more stress and wear on the bridge than needed.
__________________
Martin D-13E (2021 MiM) Last edited by LeDave; 08-01-2020 at 10:07 PM. |
#5
|
|||
|
|||
Quote:
The adjustable truss rod is there to adjust the bow in the neck - "relief". It is not there to raise and lower action. The bow in the neck should be set appropriately, then the string height set at the nut and saddle. It often happens that excessive string height is the result of too much bow and is "fixed" by adjusting it to a suitable amount. Typical amounts of relief are between about .005" and .01". If the action is too high, look to lowering the strings at the nut and/or saddle. The action is largely unrelated to the "stress and wear" on the bridge. If the angle the strings break over the saddle is very large, that increases the tipping force on the saddle, which can lead to cracking of the ends of the saddle slot at the sound hole side of the slot. "Very large" is having more than about 3/16" of saddle projecting from the top of the bridge. The greater the vertical distance - from the surface of the guitar top to the bottom of the strings - of the strings at the bridge, the greater the moment/torque on the bridge. For many guitars, the target vertical distance is about 1/2". Unless you have significantly more than that, it isn't an issue to be concerned with. |
#6
|
|||
|
|||
Quote:
__________________
Martin D-13E (2021 MiM) |
#7
|
|||
|
|||
Actually, it really isn't very complicated.
This might help, an article I wrote on basic guitar setup: http://charlestauber.com/luthier/Res...May%202015.pdf |
#8
|
|||
|
|||
Quote:
The amount of force required of your index finger to barre all 6 strings, as required for a barre chord, should not be difficult. With just a weeks "strength training" you should be able to play a 4-5 minute song, comprised of all barre chords without getting tired or cramping. Additionally, the grip strength or force required to fret that barre chord should be just as easy on the 1st fret (for your F major) as it is up higher on the neck... Properly done, the guitar should play easily and not buzz. In my opinion, the guitar being set up nicely for you has a HUGE impact on the enjoyment you get out of playing. Quote:
|