#16
|
||||
|
||||
sent you an email about something that may interest you....
__________________
"One small heart, and a great big soul that's driving" |
#17
|
|||
|
|||
Quote:
|
#18
|
|||
|
|||
Can''t wait to see it, Tom.
__________________
Mark Last edited by storm54; 09-08-2012 at 10:49 AM. |
#19
|
|||
|
|||
Mark,
Please take a look at my site. I'd be glad to do a wedge design for you. Thanks, Pete
__________________
Peter Dunn http://www.bowerbirdguitars.com/ http://www.facebook.com/bowerbirdguitars |
#20
|
||||
|
||||
Pete, nice website. You will need to post some build photographs for us custom guitar buffs.
|
#21
|
|||
|
|||
Thanks, I just put up a build thread so please check it out!
__________________
Peter Dunn http://www.bowerbirdguitars.com/ http://www.facebook.com/bowerbirdguitars |
#22
|
|||
|
|||
Quote:
|
#23
|
||||
|
||||
I'd say choosing a luthier for a handbuilt guitar, at a price point in the lower part of the range, is a balancing act: expectations, cost, and risk. I recently went through this, and based on my expectations and acceptable risk, I found a few luthiers in the $3.5K to $4K range that I seriously considered, and a few more in the $4K to $5K range. But again, this was based on my criteria and that may not be the same as yours.
__________________
Chuck 2012 Carruth 12-fret 000 in Pernambuco and Adi 2010 Poling Sierra in Cuban Mahogany and Lutz 2015 Posch 13-fret 00 in Indian Rosewood and Adi |
#24
|
||||
|
||||
At just over $5k, Matt Mustapick will build a guitar that will exceed your expectations. His OMs are glorious. He'll build with a wedge.
__________________
Circa OM-30/34 (Adi/Mad) | 000-12 (Ger/Maple) | OM-28 (Adi/Brz) | OM-18/21 (Adi/Hog) | OM-42 (Adi/Braz) Fairbanks SJ (Adi/Hog) | Schoenberg/Klepper 000-12c (Adi/Hog) | LeGeyt CLM (Swiss/Amzn) | LeGeyt CLM (Carp/Koa) Brondel A-2 (Carp/Mad) |
#25
|
||||
|
||||
My starting price is $4500 with a discount to AGF members. I am also working on a model that I hope to show before the end of the year. It is a natural series that has a no bling factor and a satin finish. Not sure yet so much about how low the price will be till im finished.
|
#26
|
|||
|
|||
My base price is (I feel) a very good deal at $3500 and I have successfully built with a wedged body before and would be open to doing it again.
Where are you located? It is always nice to be able to visit with the person you are thinking about starting a project with.
__________________
Burton Boston, MA |