The Acoustic Guitar Forum

Go Back   The Acoustic Guitar Forum > General Acoustic Guitar and Amplification Discussion > Custom Shop

Reply
 
Thread Tools
  #1  
Old 07-11-2019, 08:17 AM
Portland Guitar Portland Guitar is offline
Registered User
 
Join Date: Jan 2019
Location: Portland , Oregon
Posts: 95
Default Hollow Body Electric Build Thread-Jay Dickinson Portland Guitar

This is an Electric Hollow body with a 13 inch lower bout. It is in the sg style and will have two humbuckers each with a split coil. We are making these guitars in batches so enough materials for three is prepared.
This starts with choosing the wood, two nice pieces of zebra wood and paduak were picked up the day before. They are good hardwoods with an even grain.



Clamps and wood glue and a cnc router are the tools we use to join the boards



On the cnc we cut a straight line across the board with a half inch mill end. This produces a smooth even surface that is flat. Perfect to join.



The boards met up well, a nice even strip of glue was present in the set phase of the glue



There wasn’t enough for a full zebra wood so this lacewood piece was used instead.

Here they are finished.
Reply With Quote
Reply

  The Acoustic Guitar Forum > General Acoustic Guitar and Amplification Discussion > Custom Shop

Thread Tools





All times are GMT -6. The time now is 09:18 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ©2000 - 2022, The Acoustic Guitar Forum
vB Ad Management by =RedTyger=