#1
|
|||
|
|||
Adjusting the truss rod on an Emerald
I've recently bought an X-7, and although the action is pretty low, there is a slight amount of relief in the neck that I'd like to straighten. I've turned the truss rod twice - a quarter-turn each time - but so far there doesn't seem to be any difference. Do carbon fibre necks need a greater turn on the truss rod than wooden necks?
|
#2
|
|||
|
|||
Quote:
He sometimes reads AGF but has recently made it known that it's been a very good year and he is overflowing with orders to finish--so maybe a direct email is better than chancing he'll read the forum. He uses double action truss rods so I "think" that turning to the right will cause backbow and turning to left increases bowing (increased relief). There was a thread about truss rods on AGF in the past where someone mentioned that some brands of truss rods turned the opposite direction of others--so they warned to be sure you knew your truss rod's design. Does the turning direction I mentioned seem right or have I reversed this in my head? |
#3
|
||||
|
||||
There is the possibility that with a double-action truss-rod, if that is the case, there can be a certain amount of play (slack) at first when adjusting in the opposite direction to that previously done. how easy was it to turn?
|
#4
|
|||
|
|||
Quote:
|
#5
|
|||
|
|||
Again, an interesting reply. The resistance when I turned was pretty much what I expected, but if this slack you mention has been built into the rod, this would explain the lack of effect. Another thought is that the change may take longer to happen. I remember one tech telling me I should observe changes in relief over days rather than minutes or even hours. Perhaps the added resilience of the neck makes for longer periods of transition.
|
#6
|
||||
|
||||
Quote:
Yes, sound like this is most likely... |
#7
|
|||
|
|||
I've found the truss rod on m X-20 does not do a whole lot. Certainly not like on my wooden guitars.
|
#8
|
|||
|
|||
Mule Guitars use a backwards-thread truss rod, and mine came completely unadjusted. It was a bit of a rough learning curve. I believe he has now updated his instructions. First time I'd ever come across this, but I was told there are others.
__________________
-donh- *everything* is a tone control |
#9
|
|||
|
|||
Turning clockwise is the right way to straighten the neck. Its hard to say how much you should adjust it as it depends on where the truss rod is currently at.
You may need to give it a little more pressure. You should notice a difference in the action straight away. Our current truss rod setup is very effective and responsive. If you have any further issues with it then just drop me an email at [email protected] Alistair |
#10
|
|||
|
|||
Quote:
It's a lovely guitar, by the way. |