#1
|
|||
|
|||
Newbie Question Molds and Templates
Hello!
I have a question and I think I know the answer but it's just as likely I have it wrong. I just received a form and template supposedly from the same plans. However when I placed the template on the mold I got an unexpected result (see pictures). Am I correct in assuming these are not from the same plans? Or someone made an error? The template does match the paper plans so I assume it is correct. Thanks in advance!
__________________
Jordan Gatenby Taylor 914c (1999) Martin D-41 (Adi top) Rockbridge sj (2009) Taylor BTO (GA with adi top/EIR B+S) |
#2
|
|||
|
|||
The slightly smaller radii of the mold compared to the template looks like it's to accommodate springback in bending the sides.
Jim McCarthy |
#3
|
|||
|
|||
Doesn't look right to me. IMO the mold should match the template perimeter as closely as possible. How else could you lay things out properly?
Seems like a mistake, especially if the mold doesn't match the paper drawing. Last edited by Martin Keith; 03-26-2015 at 08:26 PM. Reason: Correction - said 'template', meant to say 'mold'! |
#4
|
|||
|
|||
Looks wrong.
|