#1
|
|||
|
|||
Guitar ID Re-attachment
This may seem like a dumb question, but I have a 1974 Guild G37 Acoustic where the inside sticker/label that identifies the serial #, Model # etc fell off. I was going to just try and reattach it in on the inside back with Elmer's glue or something like that.
Before I take such a bold step, just wanted to see if anyone else has had this problem and if using glue to reattach it is ok. Option B might be to use some good shipping tape or similar. Just want to make sure I don't damage anything. Appreciate any thoughts from all. Thanks |
#2
|
|||
|
|||
Elmer’s glue or rubber cement should work fine. If going with Elmer’s, use a moderate amount - don’t overdo it.
whm |
#3
|
||||
|
||||
I like thin hide glue, but elmers should be fine. Thin layer on label to minimize squuze out.
__________________
Dave F ************* Martins Guilds Gibsons A few others 2020 macbook pro i5 8GB Scarlett 18i20 Reaper 7 |
#4
|
|||
|
|||
3M spray glue works great for attacking paper to wood. Give a little spray and stick it on.
|
#5
|
|||
|
|||
Thanks to all for the suggestions.
|
#6
|
|||
|
|||
Quote:
whm |