#1
|
|||
|
|||
Bridge plate, drill bit/reamer size for 3 degree pins?
I've replaced a bridge plate and need some advice to get the 3 degree bridge pins to fit properly. I haven't drilled yet and want to make sure I get it right.
Do I drill with a 3/16 bit? Will it be nessasary to use a reamer to get the pins to fit correctly? I'm not replacing the bridge, just the plate, so I'm not sure I'll need to use a reamer since the existing bridge fits the pins fine. Thanks
__________________
"Guitars For Vets", the healing power of music: https://www.facebook.com/pages/Guita...09965052625358 Last edited by BB Brown; 10-16-2014 at 08:47 PM. |