#1
|
|||
|
|||
Sageworks How do you Remove adhesive
Hello everyone, I'm new here. I'm just wondering if anyone knows how to remove the Sageworks adhesive strips under the magnets inside the guitar? I remember trying to do this once with one guitar that I was selling so that I could keep the magnets but there was no possible way that I could see to remove the adhesive.
Sageworks has no video available on how to do this, neither does the entire internet. Please help! |
#2
|
|||
|
|||
__________________
Larry Martin OM-28 Authentic 1931 Taylor Cocobolo GCce 2008 Fall Limited Edition Paragon Cocobolo/cedar GOM Cervantes Signature Rodriguez Eastman Cabaret JB Tacoma JM1612C |
#3
|
|||
|
|||
Assuming that they were attached using the accompanying 3M Command Strips, you should be able to slowly pull on the tab and the adhesive strip will stretch and release.
I think in the case of the Sageworks install, the recommendation is to pull the tab more towards the side.
Last edited by CoastStrings; 07-30-2022 at 04:41 PM. |
#4
|
|||
|
|||
If the Command strip has somehow lost the tab, you can just twist it slowly. It will come loose.
|
#5
|
|||
|
|||
Quote:
__________________
Larry Martin OM-28 Authentic 1931 Taylor Cocobolo GCce 2008 Fall Limited Edition Paragon Cocobolo/cedar GOM Cervantes Signature Rodriguez Eastman Cabaret JB Tacoma JM1612C |
#6
|
|||
|
|||
Psalmist,
I googled Sageworks Guitar Supports and this is what I found. contact: https://sagework.org/pages/contact-us elmail: [email protected] Maybe try one of these methods and ask Good luck in your quest |
|
Tags |
remove adhesive, sageworks |
|