#1
|
|||
|
|||
Swapping tuners out multiple times
My ‘69 00-18 came with these replacement tuners on it that I’m not crazy about - since holes have been drilled and filled already on it is there anything I need to be wary of as regards drilling holes again for new tuners? Would I be able to put in something like open back Waverlys or would I need to go with something like the Gotoh 510’s?
IMG_2616.jpgIMG_2617.jpg
__________________
1969 Martin 00-18 2018 Frank Tate tenor guitar |
#2
|
|||
|
|||
You would be surprised how many can be fitted and it still works fine.
Older photo (yr or two ago) - This photo shows it during the repair, guess what, the customer wanted new tuners fitted that were again a different drill pattern, so I personally fix all the holes first before I drill new ones and make it pretty-ish again
__________________
Cole Clark Fat Lady Gretsch Electromatic Martin CEO7 Maton Messiah Taylor 814CE |
#3
|
|||
|
|||
Quote:
Good to know, thank you!
__________________
1969 Martin 00-18 2018 Frank Tate tenor guitar |
#4
|
|||
|
|||
Open back Waverlys (or similar tuners) should use the same bottom screw hole as the original Grover Rotomatics. You will have to drill an upper screw hole for most any kind of open back tuners.
You also will need to plug the shaft hole and redrill it smaller, or use Stew Mac conversion bushings. Standard bushings are usually 11/32" or smaller, while the 1970's Rotomatics are 3/8". Modern Rotomatics are even bigger (10mm), presumably because they are now made somewhere in Asia. The current gold tuners look like Gotoh, which are also 10mm. |
#5
|
|||
|
|||
I guess I would try to find some nice tuners with the same hole pattern as original, and shaft size as what is there now, as a first choice from the "intrude as little as possible" point of view. I like the Gotoh SX510's, that's my first choice for a traditional style guitar. If the shaft hole was too oversize, I would plug and redrill on the basis that if I did it right it will be fully covered by the tuners and completely invisible.
__________________
Brian Evans Around 15 archtops, electrics, resonators, a lap steel, a uke, a mandolin, some I made, some I bought, some kinda showed up and wouldn't leave. Tatamagouche Nova Scotia. |
#6
|
|||
|
|||
Quote:
__________________
1969 Martin 00-18 2018 Frank Tate tenor guitar |
#7
|
|||
|
|||
Quote:
__________________
1969 Martin 00-18 2018 Frank Tate tenor guitar |
#8
|
|||
|
|||
What did you plug the holes with?
Tommy Quote:
|
#9
|
|||
|
|||
Maple
Steve
__________________
Cole Clark Fat Lady Gretsch Electromatic Martin CEO7 Maton Messiah Taylor 814CE |
#10
|
|||
|
|||
Thanks for the reply Steve.
Some have suggested the use of "toothpicks" to fill the abandoned screw holes. I've also thought that the typical store bought toothpicks are too soft to do the job, especially if you need to re-drill the new holes pretty close to the old ones. Maple sounds a lot better..... Thanks, Tommy |
#11
|
|||
|
|||
Toothpicks are made from birch, which is a quite decent hardwood.
__________________
Brian Evans Around 15 archtops, electrics, resonators, a lap steel, a uke, a mandolin, some I made, some I bought, some kinda showed up and wouldn't leave. Tatamagouche Nova Scotia. |