#1
|
|||
|
|||
Replaced my ES ver.2 with a Mi-Si Align XT - Fantastic Sound
I just wanted to let you all know that I replaced the Taylor ES ver.2 with a Mi-Si Align XT. It has the under saddle LR Baggs Element pickup attached to it. The sound is fantastic and I don't have to mess with the pressure on the little round pickups that press against the saddle. The preamp plugs right into the 4 pin cable of the ES system and the volume, bass and treble controls work well. Just take the battery out of the holder because you won't need it any longer. Let me know if you have any questions about the install. I did it myself.
|
#2
|
|||
|
|||
I never knew this existed! I know you have the Es2 I have an Es1 in a 514 nylon, I would really be interested in moving over to this, as I'm not thrilled with the stock electronics, I didn't see a mention of es1 verses es2, so wondering if the setup/install would be the same, did you have to modify anything? did you keep the stock controls, or did you have replace? sounds like you used the same ones.
|
#3
|
|||
|
|||
Quote:
|
#4
|
|||
|
|||
Quote:
apparently, I need to get out more. |
#5
|
|||
|
|||
It will only work on the ES that has the flat 4 pin connector that comes from the end pin housing. The other one that won't work looks like a network connector or larger phone jack plug.
|
#6
|
|||
|
|||
I purchased mine from Blue Star Music.
https://www.bluestarmusic.com/Mi-Si-...rs_p_2478.html $159.95 free shipping |
#7
|
|||
|
|||
One Modification
One mod MiSi didn't mention in the instructions:
The shafts on the MiSi pots are shorter than the ones on the Taylor preamp. When I first installed the MiSi preamp the original knobs didn't have much to hold onto. So I had to sand the plastic spacer on the preamp side just a little bit. If you do it too much you'll also have to sand on the sleeves that go from the outside into the inside for tightening. I hope that makes sense! |
#8
|
|||
|
|||
Does ES system completely come out?
If you install the MiSi system, can you leave the Taylor saddle sensor system in place so as not to leave three holes in the bridge?
__________________
Brian St. Augustine, FL www.BrianRowlandMusic.com __________________ Martin, Taylor, Gibson, and Emerald ... too many to count. LoL |
#9
|
|||
|
|||
Quote:
__________________
Scott McNeill 000 cutaway, hog/spruce Martin 00-18 custom shop cutaway Martin 000-Jr-10E cutaway Minerva 0 12 fret Edwinson Falcon 0 cutaway, sapele/spruce Edwinson Zephyr 00 cutaway, koa/spruce Taylor 612-C Maple Grand Concert (1997) Taylor 612-CE Maple Grand Concert (1999) |