#1
|
|||
|
|||
End pin jack with jack (not solder) connection?
I see lots of piezo USTs with 2.5mm (tiny) jacks on the end of the cable which would be quite handy if there were an associated end pin jack to use with them but I'm struggling to find one.
Any thoughts?
__________________
Give a man a fishing rod... and he's got the makings of a rudimentary banjo. Last edited by shufflebeat; 09-22-2018 at 08:14 AM. |
#2
|
|||
|
|||
|
#3
|
|||
|
|||
Murrmac123 found a good endpin for your project. If you were to use this type of endpin I would highly recommend hot glueing the jack into the socket.
__________________
Taylor V-Class 814ce, 717e BE WHB, 520ce, 454ce, 420 Cedar\Maple, T5z Classic Martin D18E Retro Cordoba C10 Crossover Emerald X20 Rainsong H-OM1000N2 Voyage-Air VAD-04 Custom Les Paul Hot Rod Deville 410, Fishman Loudbox Performer |
#4
|
|||
|
|||
It's not the one I had in mind but pretty much fits the brief exactly. Thanks for that MM123 and well spotted.
@BT55, that sounds like a wise move if there is no possibility of further adaptations but I find my tastes and requirements have a habit of evolving so a measure of reversibility might be needed.
__________________
Give a man a fishing rod... and he's got the makings of a rudimentary banjo. |