#1
|
|||
|
|||
Sanding down neck
Hello, I recently purchased a Martin DCRSG for my father and let me say that this thing is a cannon. The only issue my dad is that you can feel the grain of the wood on the neck. Does anyone have any advice on how we could make the neck a lot smoother?
__________________
2020 Taylor AD27 2014 Martin D-16RGT 2010 Taylor 110 Takamine EGS330SCE |
#2
|
||||
|
||||
0000 steel wool. Works like a charm
__________________
2023 Martin GPC-11e 2023 Fender Players Tele Limited Edition - Oxblood 2022 Gibson Les Paul Standard 60’s - Unburst 2021 Fender Strat American Pro II - Black 2014 Gibson ES-335 Memphis Dot - Cherry 2013 Gibson Les Paul 50’s Tribute P90 - Tobacco 2012 Yamaha FS720 TBS |
#3
|
|||
|
|||
I know that many apply fine sandpaper or steel wool to glossy neck finishes to avoid the sticky feeling - but feeling the wood grain? Are you sure that is what it is?
__________________
Breedlove, Landola, a couple of electrics, and a guitar-shaped-object |
#4
|
|||
|
|||
Quote:
OP, is this somewhat representative of that neck: If thats the case, its seems youd have to sand right through the finish in order to level the wood. I dont woodwork, so I have no idea, but ti seems to be alot of work
__________________
The past: Yamaha AC3R (2016) Rose, Eastman AC822ce-FF (2018) The present:Taylor 614-ce (2018) Clara, Washburn Dread (2012) The future:Furch Rainbow GC-CR (2020)Renata? |
#5
|
||||
|
||||
If you are feeling open pores, then sanding will not work as you will just remove wood around the pores and keep opening new ones. You would need to use a pore filler to fill them first.
__________________
Fazool "The wand chooses the wizard, Mr. Potter" Taylor GC7, GA3-12, SB2-C, SB2-Cp...... Ibanez AVC-11MHx , AC-240 |
#6
|
|||
|
|||
What he said. And if you agree that the above pic is similar to what you're dealing with your gonna need to do a lot of sanding. a fill then a sand. would need a wheel too. hand sanding with leave some imperfections unless you are a very skilled wood worker.
|
#7
|
|||
|
|||
Scuff sand with 400 grit, rub on 6 or more thin coats of TruOil, it might take as many as 12 coats to fill the pores depending on the pores and application. You can usually do two coats a day, more if drying conditions are good. It's a lot easier than sanding back to wood and then filling pores. TruOil has a nice texture that many players prefer over nitro, and it's easy enough that a first time user has a pretty good chance of success. Just keep adding coats until you're happy with it
__________________
Rodger Knox, PE 1917 Martin 0-28 1956 Gibson J-50 et al |