The Acoustic Guitar Forum

Go Back   The Acoustic Guitar Forum > General Acoustic Guitar and Amplification Discussion > Build and Repair

Reply
 
Thread Tools
  #1  
Old 07-23-2016, 02:24 PM
mhartma93 mhartma93 is offline
Registered User
 
Join Date: Jul 2016
Location: Brooklyn, NY
Posts: 4
Default Martin DCPA 4 Fret Buzz (Neck issue)

Hey Guys,

I just picked up a 2014 DCPA 4 custom Martin and noticed a little fret buzz on the E A & D string from the 6th-8th frets, I brought it to the shop and was told that the neck dips slightly in the middle and is raised in the top of the neck. I was told that if I lowered the action on my guitar I would get fret buzz in in the lower frets and if I were to make the action higher, it would suck to play and the fret buzz in the middle of the neck would get worse.

Can anyone confirm this for me; has this tumultuous situation happened to any other lovely Martin owners before?

Thanks,
Mike
Reply With Quote
  #2  
Old 07-23-2016, 06:56 PM
mirwa mirwa is offline
Registered User
 
Join Date: Sep 2013
Posts: 2,999
Default

Without seeing your neck in person, all comments are....

Many times a neck has a wave going through the board itself and cannot be rectified through truss rod adjustments and or fret levelling.

In these situations the height of the string above the fretboard is very limited and lowering almost always encounters fret buzz.

It is common to remove all the frets and deal with the board issue and then refret to rectify

However the refret is only one option of repair, many other avenues can be approached but only after a visual assessment has been carried out

Steve
__________________
Cole Clark Fat Lady
Gretsch Electromatic
Martin CEO7
Maton Messiah
Taylor 814CE
Reply With Quote
  #3  
Old 07-25-2016, 06:29 AM
Ned Milburn Ned Milburn is offline
Registered User
 
Join Date: Feb 2011
Location: Dartmouth, NS
Posts: 3,125
Default

Truss rods affect the bow of a limited area of the neck - sometimes nut to 9th fret, sometimes only 2nd fret to 9th fret.

It is common for Martin style guitars to have a hump where the fingerboard crosses onto the body. Some manufacturers do better mitigating this than others. Some Martins are absolutely fine, others are more troublesome. The hump, if not extreme (85% of the time) can be corrected by skilful fretwork. But it is not basic fretwork. Ideally, the WHOLE fingerboard should show the same bow, and even better is to have slightly more bow on the bass side than the treble. Hence, 15" straight fret levelling bars that stew-mac and others sell will never yield an ideal result, where the neck/fingerboard bow is contiguous from 1st fret to last.

If I understand correctly from your description, your fingerboard will be improved by some careful fret-work to lower the hump. But as I mentioned in a reply to another question of yours, it is difficult to make conclusive determinations via just a few words on the internet.
__________________
----

Ned Milburn
NSDCC Master Artisan
Dartmouth, Nova Scotia
Reply With Quote
Reply

  The Acoustic Guitar Forum > General Acoustic Guitar and Amplification Discussion > Build and Repair

Tags
buzz, fret, issues, martin, neck

Thread Tools





All times are GMT -6. The time now is 11:00 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2022, vBulletin Solutions Inc.
Copyright ©2000 - 2022, The Acoustic Guitar Forum
vB Ad Management by =RedTyger=