Stainless steel for bending sides

[arie]

Originally Posted by murrmac123

24 gauge is near enough .020"

Is there any builder on the planet who uses .020" thick stainless steel slats in a Fox bender ?

And if there is, then the question would be why, when .010" does the job so much easier ?

EDIT :Uhh, you edited your post before I posted. What happened to the "don't ask for shim stock , 'cos all you will get is foil", bit ?

1. don't know

2. in an open bending form, rigidity might be helpful

3. because I decided to edit my own post.