Quote:
Originally Posted by Jphb77
I cut a 2" circle out of a piece of corian using a hole saw in the drill press. I ran a piece of 1/4" all thread through the center and sandwiched it with a nut top and bottom to hold the corian and chucked up the all thread in drill press. With it spinning in the press, I used a coarse sanding block to round the outside edges. Then unbolted it all and drilled the center hole out in the corian to 3/4" , or whatever size you need
|
You must be better equipped than me. My budget tools would not hold up to cutting corian. If you've been cutting tile and have some corian scrap laying around then I could see how that would work for you. I feel like I spent too much for my solution but I typically frequent my local hardware store for "bits n' bobs" so I earn loyalty coupons.
__________________
(2006) Larrivee OM-03R, (2009) Martin D-16GT, (1998) Fender Am Std Ash Stratocaster, (2013) McKnight McUke, (1989) Kramer Striker ST600, a couple of DIY builds (2013, 2023)
|