Thanks charles, sorry I couldn't explain this too well.
In my scenario fibre sheets are already glued together, making a complete purfling strip of 10mm x 1000mm x 1.5mm
I need to cut this strip into two 5mm x 1000mm x 1.5mm smaller strips.
If the fibre sheets were not glued, I could easily cut them with my veneer saw and straight edge, or even with some scissors, but since they are already glued, the strip is too thick for the veneer saw to cut that deep.
Tried with a sharp marking knife too, but again the strip was too thick to be cut.
|