View Single Post
Old 09-25-2013, 09:08 AM
Ned Milburn Ned Milburn is offline
Registered User
Join Date: Feb 2011
Location: Dartmouth, NS
Posts: 3,125

Originally Posted by Rex Tremende View Post
I received my Lutz spruce brace wood today. Now to figure out what to do with it. Any suggestions on splitting it?
Did you get your wood from Shane in BC?? He supplies Lutz, and if it was from him it is likely that you can adjust your bandsaw for the tilt of the grain and then rip. You should be able to see if the grain lines follow the edges or not. If they are off, then split once then line up the split face to your bandsaw fence.

You could do the same thing with a table saw if you prefer. I find the bandsaw much more friendly.

Ned Milburn
NSDCC Master Artisan
Dartmouth, Nova Scotia
Reply With Quote