View Single Post
  #8  
Old 11-23-2021, 07:48 AM
redir redir is offline
Registered User
 
Join Date: Aug 2011
Location: Mountains of Virginia
Posts: 7,657
Default

It's not uncommon to have to dress the binding channel with a chisel or some such tool to make it perfectly square. Sounds to me like your rout is not square. If it is then the binding might have a twist in it.

What are you using to 'clamp' the bindings in place? If you use the roping method then you can pull pretty much any gap closed. But if you do use rope then make sure you fit all your bindings in place then glue one of them down. That way you don't put little dents in the soft spruce at the edges.
Reply With Quote