How to cut guitar case to fit preamp?
Hi all,
I've bought a 'Tanglewood' Travel guitar and a SKB 1SKB300 Hard Case (advertised to fit Baby Taylor/Martin LX).
The Tanglewood would be a 'snug fit' (if it were not for the preamp controls) as it is with Taylor/Martin guitars, according to my research as is shown in the photos on the SKB website. (my point being that a Baby Taylor or Martin LX would have the same issue if a preamp with controls was installed)
I have a preamp in the Tanglewood with a volume and tone knob that protrude from the guitar so that it won't fit in the case (without 'squashing' the knobs). Thus I need to cut a piece out to make room for the preamp so that the guitar will fit.
Has anyone had any experince with this particular case or how to go about this in general. Essentially I don't want to 'destroy' the lining in the process....
Any insight would be appreciated.
Last edited by JazzyJ; 07-16-2019 at 08:02 AM.
|