View Single Post
  #35  
Old 06-14-2019, 06:50 AM
JonWint JonWint is offline
Registered User
 
Join Date: Mar 2016
Location: 1 hr from Nazareth
Posts: 446
Default

There is no bevel, but the contact width is only about 1/8" wide.

This is the Martin factory jig. (I ran out of pixels with enlargement.)

[IMG][/IMG]

They have a bit organizer board with about 30+ bits. Side and top ledges are cut in the same pass. The vertical guide plate may be beveled. But I don't think it is adjusted from back to top routing.
Reply With Quote