Thread
:
Harmony Stella H942 Repair Thread
View Single Post
#
35
06-20-2021, 03:44 PM
tateharmann
Registered User
Join Date: Dec 2020
Location: Minnesota
Posts: 48
Here are some shots of the neck reset thus far. To pull the neck I used a poor man's version of StewMac's heatstick and neck removal jig. If I recall, the copper rods plus the two drill bits were less than $20 on Amazon. The jig is just some clamps and boards lol.
One rod and holding the soldering iron on by hand wasn't enough so I drilled another hole and clamped the iron in place with jumper cables haha. After 20-30 minutes it was loose enough to pull. I did put some water down the holes too.
__________________
https://soundcloud.com/laguitarraclasica
Last edited by tateharmann; 06-20-2021 at
04:52 PM
.
tateharmann
View Public Profile
Find all posts by tateharmann