View Single Post
Old 01-13-2019, 10:01 AM
Pat Foster Pat Foster is offline
Registered User
Join Date: Aug 2008
Location: Spokane, Washington
Posts: 308

Originally Posted by john bange View Post
you mentioned crossover guitar...usually with a 1 7/8 nut width.

If a tuner set with a bearing at the end of the roller is your choice, make sure your head stock is wide enough at the E strings to allow the tuner plates to both screw down.
My Martin 000c crossover has a peg head that is too narrow at the E strings and one side will not seat as the bearings hit one another. This is not a problem with a plastic roller because a tiny bit can be trimmed off.

just something that happened to me...don't know about the Cordoba
Good point. I've run into this problem, since the Rubner roller is 32mm, while most others are 30mm. That's about .080" difference.
Reply With Quote