On the guitars I've done nuts for I've taken the time to make them fit snug, and then used a small drop of Elmer's School Glue (which is basically just a watered down white glue) for just a little bit of extra insurance - water soluble and just barely strong enough to keep it in place until deliberately tapped out.
Realistically a small drop of most any glue will be sufficient to do the job of holding a properly fitted nut in place - white glue, yellow glue, hide glue, CA/super glue... they've all been used successfully without causing headaches on future removal. As long as it's an appropriately small amount used, you're good to go.
Last edited by canyongargon; 02-24-2021 at 01:58 PM.
|