View Single Post
Old 02-13-2021, 11:52 AM
Tim McKnight's Avatar
Tim McKnight Tim McKnight is offline
AGF Sponsor
Join Date: Oct 2005
Location: Morral, Ohio
Posts: 5,514

Originally Posted by j. Kinnaird View Post
I surely do get a lot of good ideas from watching you build. I especially like the way you cut binding ends square on the table saw. And I really would like to have one of those little detail Sanders. Where do you get that?
Hi John,
I think you might be referring to my 2" right angle die grinder? If so, its air powered and made by Dotco. I believe they were originally made for tool and die makers for the main purpose of sanding and grinding metal. Mine comes in handy for fitting necks, detail sanding small areas like binding ends and taking just a "skosh" off here and there. Skosh is a highly technical term that many might not be aware of but I am sure its in your vocabulary so no further explanation is required.

I found one at Harbor Freight that is similar to mine [IF] this is the tool which you were referring to?
Reply With Quote