Joining Plates/Bending Sides/Neck Blank
Continued...
The side layout is drawn on the side using a template.
After being cut to profile, the sides are bent over the mold with a heat blanket.
They are then placed in a cooling jig to cool.
The mahogany-maple-walnut-maple-mahogany neck sandwich is glued up.
Order Up: One five-piece neck sandwich ready for cutting and carving.
__________________
Martin 00-18G; Waterloo WL-S; Furch: V1 OOM-SR, Green G-SR, Blue OM-CM; Tahoe Guitar Co.: OM (Adi/Hog), 000-12 (Carp/FG Mahog), 00-12 (Carp/Sinker Mahog), 00-14 (Adi/Ovangkol);
In the night you hide from the madman
You're longing to be
But it all comes out on the inside
Eventually
Last edited by OddManOut; 01-19-2015 at 03:28 PM.
|