View Single Post
Old 08-11-2017, 03:23 PM
redir redir is offline
Registered User
Join Date: Aug 2011
Location: Mountains of Virginia
Posts: 5,038

Like most plans out there you can always find something wrong, that's wrong imho. Typically a bridge is made to 5 or 6/16ths inch thick. IS that plan a model of some vintage guitar perhaps? I guess it could be part of the original design but it's not normal.

I think it would be better to set your target at 1/2 if you end up at 7/16th that's fine, any lower then that, not so good. Otherwise you could probably disregard anything I said before and build without a neck angle and achieve that height. BUt I don't think it's a good idea.
Reply With Quote