Quote:
Originally Posted by TEK
Albert,
Yes I would get your neck angle set first. Once you have that set you can make a shim to fill the gap. On mine I used the same mahogany I used for the neck. Get a good clean join up tight against the part of neck under the fingerboard and glue it to the fingerboard. Keep fitting and trimming it until it is just right on both sides. You can floss it like the neck if you want. Match the finish to the neck and it will not even be noticed by most.
TEK
|
TEK, Thanks for the ideas. I had not thought about flossing it. Great idea. It will be a slow process for me but that's fine. I just want it right. I will just look at it as another fun challenge.