Ned,
This is more about why I started this thread. The idea of using a dish to sand the rims with a radius means there will be a dome where the neck mounts. There was always talk about sanding a radius on the rims but very little talk about what to do with the neck area after. I just followed along blindly so to speak even though it did not make much sense to me.
Most of the time I just sanded the top to make everything line up and it worked fine. I was just curious what others did to correct because I felt the correction should be done before gluing the top on.
You can bet I will be slowing down and making the next one with the right angle before the top goes on.
Travis
|