View Single Post
  #13  
Old 02-02-2021, 10:35 AM
redir redir is offline
Registered User
 
Join Date: Aug 2011
Location: Mountains of Virginia
Posts: 7,657
Default

What I would suggest is to use kite string and at the bridge stick down some masking tape and draw the two center points for both low and high E-strings at your new string spacing. Then put the string in the E nut slot and pull it tight to where your new bridge pin hole markings are and observe what it looks like over the fretboard. As John mentioned if your fret ends are beveled and rolled you might need a whole fret job to get this right.

$150 bucks is a good price for such work because not only do you need a new bridge but they will have to plug the bridge plate and old holes too.
Reply With Quote