View Single Post
  #16  
Old 05-31-2022, 05:16 PM
jonfields45 jonfields45 is offline
Registered User
 
Join Date: Jun 2011
Location: Allentown, PA
Posts: 4,204
Default

Just a few small points...

None of the finishes used on guitars are hermetic. They will all allow water to pass and ultimately allow the wood to track the ambient humidity.

Maple necks of Fender design are typically flat sawn which orients the radial fibers front to back. This is good for keeping it from splintering when you pull out a fret. I believe Leo Fender's original reason, besides it being cheaper, was to keep it from being too stiff. He wanted it to pull forward under string tension for adjustment with a truss rod. However flat sawn is bad for stability against shrinkage causing fret sprout.

I think if you visit most Guitar Centers in the winter you can find plenty of Fender maple necks with fret sprout.
__________________
jf45ir Free DIY Acoustic Guitar IR Generator
.wav file, 30 seconds, pickup left, mic right, open position strumming best...send to direct email below
I'll send you 100/0, 75/25, 60/40, 50/50, 40/60, and 25/75 IR/Bypass IRs
IR Demo, read the description too: https://youtu.be/SELEE4yugjE
My duo's website and my email... [email protected]

Jon Fields
Reply With Quote