View Single Post
  #7  
Old 11-26-2018, 10:41 PM
justonwo's Avatar
justonwo justonwo is offline
Charter Member
 
Join Date: Oct 2008
Location: SF Bay Area
Posts: 5,140
Default

Quote:
Originally Posted by redir View Post
It is confusing looking at that typical graphic. Rift sawn is more wasteful and is a cut used to eliminate ray fleck that you would get on perfectly QS wood. Yes it's true that QS wood is best right in the middele but as you get away from the middle you will still have QS pieces where the vertical grain is perfectly vertical and tapers off to the edges. That's typically ok for guitar building since we can put those edges on the outside of the guitar profile.

Rift sawing tries to keep the annular rings at a steady 30 degrees or soo 'off quarter' or off vertical to try and eliminate fleck.
Quote:
Originally Posted by mirwa View Post
The best way to see a good difference is not with a top shot, but an end grain shot of cut wood.

Steve
Agree completely and I get it in practical terms. Itís just the actual diagrams for how
Reply With Quote