A razor blade is a good tool for getting the leveling real close. I usually round off the corners and even turn the edge like you would sharpen a scraper. Use a thin tape like the kind of tape you wrap Xmas gifts with and tape off the edge of the blade on each side so that only the middle of the blade, wide enough for the drip or run, is exposed. The tape will act as a stop so basically you will scrape the drip down to the thickness of the tape.
Another trick to finish that off is to press a small strip of sandpaper right on top of the drip you want to flatten with the tip of your finger and pull the sand paper out while maintaining pressure. Repeat till level then polish out the surrounding area.
|