Quote:
Originally Posted by Neil K Walk
I’ve been hunting for parts and am finding precious little locally to make different sized dumbbells. Yours looks to be adjustable. Are you using locking washers to keep the guide from working loose while the router is running?
|
I have since changed that design to eliminate the dumbell. I was building a couple Ukes and a mandolin and as you can imagine the bodies were two narrow. So now it's just a rounded adjustable block design that works just fine.
There is a threaded insert in the adjustable block and I routed out a slot so it can slide up and down. In this pic you see a dovetail slot but it's actually routed through. It's the only pic I could find but illustrates the point.
This is the old version again but just to show that there is a threaded knob that goes through the back of the board into the threaded insert of the adjustable block to lock it down tight. I think maybe I did add a lock washer to it but it's probably not even necessary.