View Single Post
Old 01-03-2019, 10:26 AM
john bange john bange is offline
Registered User
Join Date: Jan 2008
Location: seattle
Posts: 338

you mentioned crossover guitar...usually with a 1 7/8 nut width.

If a tuner set with a bearing at the end of the roller is your choice, make sure your head stock is wide enough at the E strings to allow the tuner plates to both screw down.
My Martin 000c crossover has a peg head that is too narrow at the E strings and one side will not seat as the bearings hit one another. This is not a problem with a plastic roller because a tiny bit can be trimmed off.

just something that happened to me...don't know about the Cordoba
Martin 0-18t tenor guitar
Ode model 21 long neck banjo
Zach Hoyt 10" baritone banjo/uke
LoPrinzi model A baritone uke
Kerry Bannister mahogany nui (big baritone) uke
Kerry Bannister mahogany baritone uke
Harmony baritone uke
Reply With Quote