View Single Post
Old 06-17-2019, 01:56 PM
gmel555 gmel555 is offline
Charter Member
Join Date: Sep 2018
Location: Lower Slower Delaware
Posts: 2,471

Did you loosen the ES2 saddle sensors first before pulling out the old saddle? The procedure is:
1) slightly loosen the 3 pickup sensors
2) pull out old saddle
3) put new saddle in
4) gently retighted the 3 sensors

From Taylor website:
Note: The saddle should not be removed or replaced without first loosening the adjustment screws located on the top of the pickup housings. Otherwise the pickup could be damaged.
To remove the saddle: The pickup sensors must first be loosened (backed away from the saddle) by loosening the pressure adjustment screws located on top of the housings behind the saddle. The adjustment will require a .050 hex key (Allen wrench).

Last edited by gmel555; 06-17-2019 at 02:07 PM.
Reply With Quote