How to file a saddle in a slope?
Hi.
I need to file the bottom of a saddle so the high E is lower than the low E.
I’ve measured how much is needed to sand off and I marked the line. Imagine a diagonal line which means gradually taking off more material from the low E to the high E. Where the high E requires more material to be removed from the saddle to create this slope.
The problem I’m facing is that when I try to sand the saddle I get this curvature and then I end up sanding more than I need in order to remove that curvature.
Is there a smart way to sand it to the slope I need?
|