Quote:
Originally Posted by JonWint
I use a small piece of folded paper towel that just covers the dented area. Saturate the towel with water. Apply hot soldering gun's flat tip to the towel. Remove heat before all water steams away. Repeat until dent "grows" back to flush (or close to it).
|
the trick here is not to raise all the wood that's surrounding the "dents".
I think only something with a small pen-like tip would work here. Something that would fit in the small indented grooves. Maybe the edge or tip of a knife or heat up the tip of a screwdriver?
__________________
Gear: PRS Hollowbody II Piezo, Martin HPL 000, PRS Angelus A60E, Martin 000-15M
|