View Single Post
  #3  
Old 11-10-2019, 05:12 PM
Merak Merak is offline
Registered User
 
Join Date: Jul 2018
Location: West Central Wisconsin
Posts: 145
Default

The holes are the same diameter as the wide end of the pin so to ream the holes would require a larger pin.
Maybe I wasn’t clear, the hole is straight, the pins are tapered so the pins only bear on the outer edge of the hole. Has anyone used a tapered reamer to make a tapered bore out of a straight bore and what size pins did you end up with?
__________________
Worry is payment on a debit you may never owe.

Last edited by Merak; 11-10-2019 at 06:10 PM.
Reply With Quote