View Single Post
  #40  
Old 07-01-2013, 01:34 PM
charles Tauber charles Tauber is online now
Registered User
 
Join Date: Feb 2011
Posts: 6,488
Default

Quote:
Originally Posted by Tom West View Post
Use a pulley to match shaft diameter, have a machinist machine off the outside half of the V, on that flat surface drill 4 screw holes, put the altered pulley on the shaft and run the flat up to the end of the plywood discs, install 4 screws, tighten set screws on shaft.
Tom

At the ends of the drum, I cross-drilled the shaft, inserted a pin through the hole longer than the diameter of the shaft and put screws into the ends of the drum adjacent to the pin, preventing relative rotational motion of shaft and drum. Lots of ways that it could be done, including keys.

Last edited by charles Tauber; 07-01-2013 at 01:42 PM.
Reply With Quote