Quote:
Originally Posted by jim_pridx
Lookin' pretty sweet, Ryan!
|
Thanks Jim!
So continuing on...after putting the findings on and scraping them flush to the sides, we then fit the bridge and the neck. This allows us to prep the body for the finish application. When we get everything put together, we take a step back and make sure everything is lining up properly.
We then tape off the areas for the bridge and under the fretboard extension. This will allow us to easily pull the finish off of these areas after all the lacquer is applied. We will then glue the bridge and fretboard straight wood to wood.
And a couple other shots in the white...even though there is not much white on this guitar.
Thanks for following along!