Taylor ES1.3 Issues
I recently purchased a 2011 414CE and ran into a couple of issues with the electronics and wanted some guidance.
First off, I have yet to find a 9V battery that will fit the housing properly enough for it to slide all of the way in and latch. I can force a regular Duracell to the point that it almost latches, but then had to pry it back out.
Second, even when I just slide a battery in without the holder and shim it in place, the red LED only comes on for a couple of short flashes as I slide the end of the cable in. I can not get the LED to stay lit, meaning the pickup is not on.
I did remove the battery end and could not find anything that looked visibly wrong or obvious. Any hints, tips or tricks before I pay someone to work on this?
Last edited by spotco2; 01-16-2019 at 10:35 PM.
Reason: Change title
|