I do these weekly under warranty.
I read here numerous replies over the years of using ca, whilst I do not doubt it works for them, it does not work for me.
A typical repair for me involves peeling the binding back an inch past the loose section on each side. Using a razor blade I scrape residual glue and bits of the inside of the binding and I also scrape clean the binding ledge of the guitar.
With some heat from a heat gun, i lightly stretch the binding
I use a cellulose based glue, typically these days i melt down fresh new binding from martin with some acetone and make my own glue.
Glue and clamp in place for 24hrs.
After 24hrs, i lightly scrape the binding flush with the surrounding wood.
Then apply finish to the binding and any voids (this part takes the longest)
Job finished
Steve
__________________
Cole Clark Fat Lady
Gretsch Electromatic
Martin CEO7
Maton Messiah
Taylor 814CE
|