Hi
Just got this amazing little Guild m140. It comes with the factory end pin non-attached and when I press it in by hand (without using much force) it's still about 3mm from being flush with the guitar. Do I just give it a few gentle taps with a rubber hammer or does it look like the hole needs to be reamed? I of course want it to be tight so it doesn't fall out but don't want to push it if it looks like it will take too much force to get it in there...
Here is a photo that shows how much it is "sticking out" (and again this is without forcing it):
https://imgur.com/a/Qr0Y7lS
From what I can see the hole is reamed/shaped as it should be.
Thanks!
Hans