Quote:
Originally Posted by printer2
Use high temperature silicon. Bend using the un-repaired side. You will probably get some offgassing for a while. Or just use it as it is with the bad side out. Watch your temperature, use a metal strip on either side of the blanket to keep the temperature even. If you are planning on bending many sides order another blanket, while the above will work it is not great as heat is concentrated at the wires. I doubt you will find much else to use to repair it. Cean it with alcohol first and make sure it ir evaporated.
|
Thanks, this worked, I got some Permatex Red 650° silicon in a tube. Cleaned with alcohol, Slathered it on, rubbed it in a bit, then smoothed by putting masking tape over it. Warmed the blanket up to 100 F to speed dying. When dry, I peeled off the masking tape.
Not sure how long it will last but I've done two sides so far.
https://www.homedepot.ca/product/per...0ml/1000169229