Quote:
Originally Posted by john bange
you mentioned crossover guitar...usually with a 1 7/8 nut width.
If a tuner set with a bearing at the end of the roller is your choice, make sure your head stock is wide enough at the E strings to allow the tuner plates to both screw down.
My Martin 000c crossover has a peg head that is too narrow at the E strings and one side will not seat as the bearings hit one another. This is not a problem with a plastic roller because a tiny bit can be trimmed off.
just something that happened to me...don't know about the Cordoba
|
Good point. I've run into this problem, since the Rubner roller is 32mm, while most others are 30mm. That's about .080" difference.